The large generating set is the most widely used power generation equipment in the market at present. It relieves the tension of electricity consumption and brings convenience to people. The manufacturer of the major power generation equipment of the comler generator is all over the domestic market. The following is a simple analysis of the oil filter element by the comler generator factory.
The structure of the oil filter element is simple, and its internal filter paper and some important parts are difficult to distinguish from the appearance. Therefore, all kinds of high imitation filter elements emerge in an endless stream, and the price is low, so some users buy fake and inferior products in order to save money. The oil filter must choose the regular brand, if there is no quality guarantee filter core will cause failure of the unit, causing damage to the unit, once the machine is mixed with impurities, it will not be lost.
Oil filter core replacement steps:
The first step: expelling the waste oil
First drain the waste oil in the fuel tank, place the old oil container under the oil pan, open the oil drain bolt and drain the waste oil. When dripping oil, keep the oil dripping for a while. Make sure that the waste oil is discharged clean. (oil through use, will produce a lot of impurities, if the replacement of the discharge is not clean, easy to block the oil road, resulting in oil supply is not smooth, resulting in structural wear.
Second step: remove the old oil filter core
Move the old oil container to the bottom of the machine and remove the old filter element. Be careful not to let the waste oil dirty the inside of the machine.
Third step: preparatory work before the oil filter is installed
The technical experts of the comler generator company tell users to replace the new machine filter without using the oil filled in the filter element first.
Fourth step: install the new oil filter core
Check the oil outlet at the installation location of the oil filter element, clean up the dirt and residual oil. Before the installation, first in the position of the oil outlet seal ring, and then the new machine filter slowly screwed up, machine filter do not tighten, in general, the hand tightened after the wrench, then wrench wrench 3/4 ring. When paying attention to the new filter cartridge, the wrench should not be overforced by the wrench, or the seal ring inside the filter core will be damaged easily, and the sealing effect is worse and the filtering effect can not be achieved.
Fifth step: add the new oil to the oil tank
Finally, injecting the new oil into the oil tank, if necessary, use a funnel to prevent the oil from being poured outside the engine. After filling, check if there is any leakage at the bottom of the engine again.
If there is no leakage, check the oil gauge and see if the oil is added to the line, we recommend that it be added to the line. In daily work, you should check the dipstick regularly, so that the oil is less than offline.
